How can we calculate the pace rate for CTM in crushing value ... - Civil4M
Check your CTM loading unit, in most of the cases it is Kn/sec. do calculation to arrive at rate of loading required to apply load for 10 minutes with uniform loading.

Checklist for all kinds of tiling works including grouting ... - Civil4M
Uniform compaction with straight edge / flat shovel has been ensured. Floor Tiling Work Pre Execution Checks: Are all the required tools available at site? The surface on which tiles to be laid made moist, free from dust and other contaminations. The plan / setting out for tiling done. All the tiles are of required dimensions.

A one dimensional flow is one which - Civil4M
A one dimensional flow is one which (a) is uniform flow (b) is steady uniform flow (c) takes place in straight lines (d) involves zero transverse component of flow (e) takes place in one dimension. The correct Answer Is (d) involves zero transverse component of flow

The contact pressure of rigid footing on cohesive soils is
The contact pressure of rigid footing on cohesive soils is 1] more in the centre than at the edges 2] less in the centre than at the edges 3] uniform...

General energy equation holds for | Civil4M
General energy equation holds for (a) steady flow (b) turbulent flow (c) laminar flow (d) non-uniform flow (e) all of the above. The correct Answer Is (d) non-uniform flow

A soil having particles of nearly the same size is known as
A soil having particles of nearly the same size is known as 1] uniform soil 2] poor soil 3] well graded soil 4] coarse soil

What is Maximum Flyash Content in Concrete mix design
I want to know. As per IS codes what is the maximum flyash content i can add into concrete as a replacement of Cement. Can i add flyash beyond the limit specified in IS code. This is important interview question, i want correct answer for it.

How do I calculate the required numbers of cover blocks
Go to your Project actual execution of work, then tell them to put the cove blocks in place as per what you think is sufficient for horizontal surfaces like slab. then walk on it or do some movement which may happen during concreting and check if still you able to find a uniform covering to reinforcement, if cover to reinforcement is still seen uniform then you have placed required number of ...

Method of laying of BC DBM BM and SDBM for main and service roads - Civil4M
After spreading of coarse aggregate rolling shall be carried out with an 8 -10 smooth steel wheel roller without cursing of aggregates until the compacted coarse aggregate has firm surface and texture that will allow free and uniform penetration of the bituminous material.

      >> Live EBAY Auctions